When i using multicam mode (nine- split)
1. Usually I press a key-shortcut to turn-on nine-split. Everything works fine, but sometimes MC 8.5 loads the working sequence in the source monitor an leaves it there. Even after switch back from multicamera mode.
2. When i use the autosequence command in MC 8.5 it lays everything ok, but begins audio tracks from A2 - skipping A1.
i mean it shifts everything by 1 audio track. puts source a1 on a2, source a2 to a3 ...... I can fix it with red arrow but its very annoying.
mc 8.4.4 was ok.