When trimming an L-cut (where the picture cuts before the audio) the audio that is monitored is for the A-side clip. When trimming a J cut (where the audio cuts before the picture) the audio that is monitored is for the B-side clip.
Is there a way to change that?
When doing a single-side trim on a J cut, it doesn't play any audio! Presumably becasue the next side isn't actaully trimming. But that makes it pointless. A nd B side trims should always play the audio with their respective sides, and AB roller trims should play the audio depending on the direction of the trim.
Is there a way to do this? In fine cutting stage, it's very frustrating! I just have to look at the waveform to make it right and that is not great!
Nathan